Supplies Needed:

Snow Flake Paper Punch or Snow Flake Stickers

Sheer Ribbon or other Fiber

Card Stack or Pre-cut Cardstock (5.5" x 8.5") - Yellows

White Cardstock for Matting (inside cover) and Signature Side

Steps:

1.  Using your computer type up "Let It Snow" and print onto the white vellum.

2.  Cut piece of sheer ribbon approx. 5" long.  If you cut it too short you won't have room to tie the ends.  Remember, if it is too long once it is on your card you can always trim it, but if you cut it too short -- you'll be cutting again.

3.  Punch out three snowflakes (or use stickers).

4.  Cut window into card for vellum wording.

5.  Adhere vellum wording to the inside don't worry about aligning vellum -- just the wording because you are going to cover with a piece of white cardstock trimmed.

6.  Mat inside of cardstock and the signature side of card.